248
edits
Lathe, metal (Challenger 1660G) ID:46: Difference between revisions
Lathe, metal (Challenger 1660G) ID:46 (view source)
Revision as of 21:28, 24 February 2023
, 24 February 2023→Documents: add subcategory placeholders ToDo
(add Jank, powerfeed details, attempt to embed vid) |
(→Documents: add subcategory placeholders ToDo) |
||
| (8 intermediate revisions by the same user not shown) | |||
| Line 55: | Line 55: | ||
<br /> | <br /> | ||
== Jank == | ==Jank== | ||
=== Power Feed === | ===Carriage Lock=== | ||
If the carriage doesn't freely/easily move in the X direction, there's a fat hex bolt head sticking up on the right side of it that needs loosening. | |||
(add pic here) | |||
===Power Feed=== | |||
Note that while <u>generally gears/speeds shouldn't be changed while the lathe is in motion</u>, from https://forum.protospace.ca/t/can-t-get-lathe-power-feed-to-work/3568/8<blockquote>Set it to a lowish speed like 400 or less and bump the jog button. Then start wiggling leavers while it’s coasting down and watch the drive shaft and screw. You’ll feel it when it engages and the shafts will start spinning… | |||
The threading lead screw and the power feed drive shaft are taken off at different points in the gear train. It is possible to jiggle a leaver and get one to start spinning while the other is still not engaged properly and requires further jiggling. | The threading lead screw and the power feed drive shaft are taken off at different points in the gear train. It is possible to jiggle a leaver and get one to start spinning while the other is still not engaged properly and requires further jiggling. | ||
The XYWZ lever is the worst and usually requires persuasion to engage. The gears are all straight cut, and all may require sufficient wigglage before they cooperate. And the number dial is keep turning until it works. It’s about 1/4 past the number you want.</blockquote>[[File:20180206_230213_720p.mp4|frameless]] | |||
<br /> | |||
==Documents== | |||
== | === Reference === | ||
*[http://www.southern-tool.com/store/birmingham_lux-1640-g_lathes.php Sales page for 1640T and 1660T models] | *[http://www.southern-tool.com/store/birmingham_lux-1640-g_lathes.php Sales page for 1640T and 1660T models] | ||
| Line 74: | Line 80: | ||
*[https://wiki.protospace.ca/images/5/5e/LUX-Matter_1600_Series_Instruction_Manual.pdf 1500/1600 Instruction Manual and Parts List] | *[https://wiki.protospace.ca/images/5/5e/LUX-Matter_1600_Series_Instruction_Manual.pdf 1500/1600 Instruction Manual and Parts List] | ||
<br /> | === Training === | ||
(training material linked here?) | |||
=== Practical Project === | |||
(tired of digging this out of drive, insert here?)<br /> | |||
==Tooling== | ==Tooling== | ||
{| class="wikitable mw-collapsible mw-collapsed" | {| class="wikitable mw-collapsible mw-collapsed" | ||